Search This Blog

Thursday 17 June 2010

FAMAG Quiz!













The person with the most correct answers wins a bottle of bubbly and a selection of FAMAG goodies! In the event of a tie, names will be drawn from a hat by our new Sales Manager, Chris, when the competition closes on the 30th of June. The winner will be reported here and informed by email.

Questions:

1) Who invented the Forstner Bit and when? (2 marks)

2) What are the smallest and largest diameters of bits in the 3500 series? (2 marks)

3) What do the letters F, A and M stand for in FAMAG? (3 marks)

4) Should a plug cutter ideally be used in the middle of a board or close to an edge? (1 mark)

5) I want to bore through timber, thin metal and brickwork in a single pass, which series of FAMAG bits should I use? (1 mark)

6) What range of bit sizes will a 2202.000 Vario countersink fit? (1 mark)











7) The photo above shows a set of hollow Bormax forstner bits that allow the centre pin to be replaced with a standard drill bit. In what situation would this be useful? (1 mark)

8) Bormax3 are the only carbide tipped forstners in the world that can be used safely in which type of drill? (1 mark)

9) I want to drill a hole in some Lignum Vitae, should I use CV or HSS-G bits? (1 mark)

10) In which German town have FAMAG been continuously producing drill tooling since 1865? (1 mark)

Please email your answers to me or use the contact message form on workshopheaven.com.

No comments:

Post a Comment